Everlast PowerPlasma50 Plasma Cutter
Customers, who are serious about their plasma cutters, look no further. The PowerPlasma line offers premium cut quality and cut thickness at one of the best prices in the industry. The 50-100 amp line of Plasma cutters offers one of the widest range of plasma cutters available, in 1 and 3 phase designs. The proven designs are capable of being adapted to many home built and professionally manufactured CNC and track cutting systems. Adjustable post flow increases consumable life and helps prevent torch overheating. Each model comes ready to cut, with water trap, air connection, extra consumables and lengthy power cord. You supply the air compressor, air line and the power plug.
If you need to cut aluminium, stainless, or steel, the pilot arc technology can help you to manage consistent cuts on the dirtiest or scrappiest piece of metal that you can find. It also excels at cutting expanded metal quickly without the delay of having to restart the arc every time so that cutting speed is maintained without interruption.
Commercial duty cycles of 60% at maximum amperage allow you to keep cutting for extended periods of time without stopping or taking cool down breaks. If you do over extend the duty cycle, the unit is equipped with overcurrent / overheat protection to prevent costly failures.
Take a look at the power plasma performance and design by viewing these videos.
Ideal for regularly cutting a maximum of: 12.5mm
Maximum cut for quality @ 25-30cm per minute (steel) 20mm
Maximum severance cut (steel) 25mm
Output amp/volt range: 20 A/88 V-50 A/100 V
Start type: CONTACT/BLOWBACK
Pilot arc: YES
Cnc capability: YES
Torch type: S-45
Gouging capability: Limited (must use extended Trafimet torch consumables available from trafimet retail dealers for limited/light duty gouging)
Input voltage/phase: 220-240 V 1 PH 50/60 Hz
Max inrush amps@rated voltage: 240 V @ 37 A
Max running amps @ rated voltage: 240 V @ 29 A
Open circuit voltage (ocv): 200 V
Adjustable post flow timer: YES 0-60 S/CONSTANT FLOW
Amps/volts @ 60% duty cycle (10 min): 50 A/100 V
Amps/volts @ 100% duty cycle (10 min): 40A/96 V
Recommended operating air pressure: 55-65 PSI
Recommended compressor capacity: 4 CFM@ 90PSI/60L tank
Overcurrent/duty cycle warning-interrupt: YES
Low air pressure cut-out: YES
Features & Benefits
Easy starting with Pilot arc allows easy cutting of rusty and painted metals.
Cuts virtually any type of metal with ease.
Simple to use torches with inexpensive service parts and consumables.
High duty cycle @ 60% of rated amperage capacity.
Exceptionally clean, smooth cuts.
Adjustable Post Flow (power plasma only) control up to 60 seconds to improve consumable and torch life.
Front air pressure adjustment makes adjusting pressure easy and painless. (PowerPlasma only)
Front air pressure gauge allows quick verification of air pressure.
Over Current and Air Pressure light indicators keep you updated on your units operating condition.
Suitable for use with 8500 W "clean power" generators.
Recommended Areas Of Use
Cutting in all conditions where Oxy Fuel cutting is impractical, slow, unsafe, expensive, or otherwise restricted or undesirable.
Excellent choice for smooth cut requirements without warping metal from high heat input typical of Oxy fuel torches.
Consumable starter kit
Air pressure gauge
Welding helmet with special 7 shade for plasma cutting
Virtually all types of metal