Everlast PowerTig 200DX Tig Welder
Features & Benefits
Stable, smooth arc characteristics with good puddle wet in.
Portable and lightweight with industrial capability.
Adjustable weld parameters for 2t/4t operation.
Pulse function increases weld quality and reduces overall heat input to help control burn through on thin metals.
Easy to connect DINSE 35/70 style torch connectors on torch and quick connect gas line allows quick setup.
Digital readout for accurate setting of amperage while in torch switch mode.
Colour coded controls are easy to find and understand.
Ergonomic styled torch and accessories.
Special 240V outlet designed for operation with the optional Everlast WC 300 water cooler.
Includes post flow and down slope control for additional parameter selection ability.
NOTE: For use with generators, this welder requires a MINIMUM of 7500 watts of continuous output and be designated as "clean power" by the generator manufacturer. For best results, a higher output generator may be required. Use with generators not designated by the generator manufacturer as a "clean" power source may void warranty.
Not recommended for stick operation with E6010.
Over Current Warning - yes
Voltage - 240V 1 PHASE
Max Start Input Amps - 30.8A @ 240V
Max Running Amps - 25A @ 240V
TIG (GTAW) Amps/Volts @ Duty Cycle
-200A, 18V @ 60%
-160A, 16.4V @ 100%
Start Amps(Initial) - no
End Amps(Final) - no
Arc Force Control(DIG) - no
Up Slope Timer - no
Down Slope Timer - 0-5 s
Spot Timer - no
Pulse Frequency Control - .5-25 Hz
Pulse Time On(Width) - 10-90%
Pulse Amp Ratio - 5-95%
Lift Start Tig - yes
High Frequency Start - yes
4t/2t Remote - yes
AC Frequency Control - 5-250 Hz
AC Balance Control - 30-70%
AC Square Wave(Aluminium) - yes
Pre-Gas Flow Timer - no
Post Flow Timer - 0-25 s
Stick (SMAW) Amps/Volts @ Duty Cycle
- 160A, 26.4V @ 35%
- 130A, 25.2V @ 60%
- 100A, 24V @ 100%
Shipping Weight 37kg
Recommended Areas Of Use
Gas-cooled 4metre WP 26 series torch with built in remote switch for 2T/4T operation.
Consumable Starter Kit (Tungsten not included.)
SMAW electrode holder-Stub type. (subject to change)
Aluminium (PowerTig Series only)